Individual Bearings

This is the Bearing Blaster from RPM.

Blast away debris from your bearings and extend bearing life with the RPM Bearing Blaster! This simple, two piece tool, works with your favorite cleaning agent, such as Motor Spray, WD-40, electrical contact cleaner, etc. (any cleaner that is pressurized and has a directional spray tube).

The RPM Bearing Blaster has an open, flow through design that eliminates back-pressure problems which also permits more efficient elimination of dirt and grit from the bearings being cleaned.

This tool uses hand pressure to hold the bearing in place during cleaning which means easier access to the bearings and makes cleaning bearings much quicker. By using hand pressure, you will know for sure the cleaning agent is passing through the bearing and not around it.

The Bearing Blaster works with all bearings* with a minimum I.D. of 3mm. and a maximum O.D. 19mm. Standing at a mere 29mm tall and 45mm in diameter, it will be the smallest, most effective tool in your tool box!

No other bearing cleaning method currently available compares to the effectiveness of the RPM Bearing Blaster!

This is a packet of (4) 5x10 metal shielded clutch bearings from Kyosho included in most of their nitro powered kit.

This is a packet of (4) 8mm x 16mm x 5mm bearings from Team Losi Racing.


This set includes:

• Four 8x16x5mm bearings

This is a packet of (2) 6x3 Flanged Ball Bearings from Kyosho to Ball race the steering on their Ultima and Optima.

This is a packet of two 8 x 12 x 3.5mm Flanged Ball Bearings, (Rubber) from Team Losi, for their new 1/4 Promoto-MX Motorcycle.

This is a packet of two 7 x 14 x 5mm Ball Bearings, (Rubber) from Team Losi, for their new 1/4 Promoto-MX Motorcycle.

This is a packet of (4) 6x12mm bearings from Team Losi Racing.


This set includes:

• Four 6x12mm bearings

This is a packet of (4) 8mm x 14mm x 4mm bearings from Team Losi Racing.


This set includes:

• Four 8x14x4mm bearings

This is a packet of two 4 x 10 x 4mm Ball Bearings, (Rubber) from Team Losi, for their new 1/4 Promoto-MX Motorcycle.

This is a packet of (4) 6mm x 10mm x 3mm bearings from Team Losi Racing used in the steering linkage/servo saver assembly of their 8IGHT range of buggies and truggies.


This set includes:

• Four 6x10x3mm bearings

This is a packet of (4) 8mm x 14mm x 4mm Flanged Bearings from Team Losi Racing.


This set includes:

• Four 8x14x4mm Flanged Bearings

This is a packet of (4) 5mm x 11mm x 4mm bearings from Team Losi Racing.


This set includes:

• Four 5x11x4mm bearings