RPM
RPM Bearing Blaster (RPM 81170)
This is the Bearing Blaster from RPM.
Blast away debris from your bearings and extend bearing life with the RPM Bearing Blaster! This simple, two piece tool, works with your favorite cleaning agent, such as Motor Spray, WD-40, electrical contact cleaner, etc. (any cleaner that is pressurized and has a directional spray tube).
The RPM Bearing Blaster has an open, flow through design that eliminates back-pressure problems which also permits more efficient elimination of dirt and grit from the bearings being cleaned.
This tool uses hand pressure to hold the bearing in place during cleaning which means easier access to the bearings and makes cleaning bearings much quicker. By using hand pressure, you will know for sure the cleaning agent is passing through the bearing and not around it.
The Bearing Blaster works with all bearings* with a minimum I.D. of 3mm. and a maximum O.D. 19mm. Standing at a mere 29mm tall and 45mm in diameter, it will be the smallest, most effective tool in your tool box!
No other bearing cleaning method currently available compares to the effectiveness of the RPM Bearing Blaster!
Blast away debris from your bearings and extend bearing life with the RPM Bearing Blaster! This simple, two piece tool, works with your favorite cleaning agent, such as Motor Spray, WD-40, electrical contact cleaner, etc. (any cleaner that is pressurized and has a directional spray tube).
The RPM Bearing Blaster has an open, flow through design that eliminates back-pressure problems which also permits more efficient elimination of dirt and grit from the bearings being cleaned.
This tool uses hand pressure to hold the bearing in place during cleaning which means easier access to the bearings and makes cleaning bearings much quicker. By using hand pressure, you will know for sure the cleaning agent is passing through the bearing and not around it.
The Bearing Blaster works with all bearings* with a minimum I.D. of 3mm. and a maximum O.D. 19mm. Standing at a mere 29mm tall and 45mm in diameter, it will be the smallest, most effective tool in your tool box!
No other bearing cleaning method currently available compares to the effectiveness of the RPM Bearing Blaster!
Keep your bearings clean
RPM Pinion Case (Black) (RPM 80412)
This is the Black Pinion case from RPM designed for carrying 48 pitch pinions.
Just one small nick on a pinion can eventually destroy a plastic spur gear! With that in mind, RPM designed this case that holds each pinion on its own post and the lid snaps shut, so there is no need to tighten the set-screw to hold the pinions in place! Included with the case is a peel-off decal sheet with two pinion to spur gear ratio charts for both 48- and 64-pitch gears.
The appropriate chart can be placed in the recessed area on the bottom of the case. Also on the decal sheet is a set of numbered squares from 14 to 31 (gear teeth), that can be adhered to the inside of the case. There are ten blank squares so you can write in your own numbers if needed.
Just one small nick on a pinion can eventually destroy a plastic spur gear! With that in mind, RPM designed this case that holds each pinion on its own post and the lid snaps shut, so there is no need to tighten the set-screw to hold the pinions in place! Included with the case is a peel-off decal sheet with two pinion to spur gear ratio charts for both 48- and 64-pitch gears.
The appropriate chart can be placed in the recessed area on the bottom of the case. Also on the decal sheet is a set of numbered squares from 14 to 31 (gear teeth), that can be adhered to the inside of the case. There are ten blank squares so you can write in your own numbers if needed.
Keep your pinion gears safe
Out of Stock
$21.50 Inc Tax
- 1