Kyosho MP9 Nitro Buggy Parts
Kyosho High Quality Clutch Bell (13T) (KYO KP 97035-13)
This is a High Quality 13T Clutch Bell from Kyosho.
Uses (2) 5x10x4 Clutch Bearings
Avid Racing Concepts Bearing Kit: Kyosho MP9 / MP10 (AVD AVKYO MP9)
This is a full bearing kit by Avid RC for the Kyosho MP9.
Bearing Kit fits:
Bearing Kit Includes:
Bearing Kit fits:
- Kyosho MP9
- Kyosho MP9 TKI2
- Kyosho MP9 TKI3
- Kyosho MP9 TKI4
- Kyosho MP10
Bearing Kit Includes:
- 14 x 8x16x5 Revolution Bearings
- 4 x 5x11x4 Revolution Bearings
- 4 x 6x10x3 Revolution Bearings
- 2 x 5x10x4 Revolution Bearings
Complete set of bearings
Kyosho Fuel Tank: MP9 & MP10 (KYO KP IF444C)
This is a replacement Fuel Tank from Kyosho for their MP9 & MP10 1/8 Scale Buggy Kits.
Packet includes:
Packet includes:
- 1 x fuel tank
- 4 x rubber grommets
- 1 x factory installed pull handle.
Keep your fuel tank healthy to remain engine tune
Kyosho Front Hub Carrier Set: MP9 (KYO KP IF421)
This is a Front Hub Carrier Set from Kyosho for their MP9 1/8 Scale Buggy Kit.
- 1 x left side carrier
- 1 x right side carrier
- 4 x carrier inserts
Includes carrier inserts
Out of Stock
$31.50 Inc Tax
Kyosho High-Grade Air Filter Sponges (2): MP9/ST-RR (KYO KP IF345-1)
This is a packet of (2) High-Grade Air Filter Sponges from Kyosho for their MP9 1/8 Scale Buggy and ST-RR Truggy Kits.
The Kyosho high grade air filter features a new, high-density foam element and pre-filter. The high-density foam captures the smallest particles to keep your engine in top condition, yet it allows plenty of airflow so the engine can produce maximum power.
The angular cut of the Kyosho high grade air filter foam pre-filter creates more surface area, which means the engine will breathe well even when other filters begin to compromise performance.
The Kyosho high grade air filter features a new, high-density foam element and pre-filter. The high-density foam captures the smallest particles to keep your engine in top condition, yet it allows plenty of airflow so the engine can produce maximum power.
The angular cut of the Kyosho high grade air filter foam pre-filter creates more surface area, which means the engine will breathe well even when other filters begin to compromise performance.
High-density foam element and pre-filter
Out of Stock
$30.50 Inc Tax
Kyosho Brake Pads (2): MP9 (KYO KP IF416)
This is a packet of (2) Brake Pads from Kyosho for their MP9 1/8 Scale Buggy Kits designed to deliver reduce brake fade, with increased stopping power.
Reduced brake fade & increased stopping power
Kyosho 1/8 Plastic Wing (Black): MP9 TKI4 (KYO KP IF491BK)
This is the replacement Black Plastic Wing from Kyosho included with the MP9 TKI4 Buggy Kit.
Packet includes:
Packet includes:
- (1) Black Kyosho 1:8 Wing
- (2) Wickerbills
- Wickerbill Hardware (high and low downforce)
2 wickerbills included for high or low downforce
Out of Stock
$29.95 Inc Tax
Kyosho Light Weight Shock Bushings (4): MP7/MP9/MP10/STRR (KYO KP IF346-04L)
This is a packet of Lightweight 7075 Shock Bushings from Kyosho for their MP9 & MP10 1/8 Scale Buggy and ST-RR Truggy Kits.
These Shock Bushings lower the overall weight and center of gravity and are anodized for looks and durability.
These Shock Bushings lower the overall weight and center of gravity and are anodized for looks and durability.
Lower CoG and overall weight on vehicle
Out of Stock
$29.95 Inc Tax
Kyosho 5.8mm Hard Anodized 7075 Aluminum Lower Sway Bar Ball (5) (KYO KP W0201HB)
This is a set of replacement 5.8mm Hard Anodized 7075 Lower Sway Bar Balls from Kyosho.
These are used in the lower ball end of the sway bar ball ends.
Extremely light, these parts lower stiction in the ball end and allow free movement. These parts can also be used to lower overall weight on all Inferno kits.
These are used in the lower ball end of the sway bar ball ends.
Extremely light, these parts lower stiction in the ball end and allow free movement. These parts can also be used to lower overall weight on all Inferno kits.
Light and strong
Kyosho Battery & Receiver Box Set (White): MP9 TKI3 (KYO KP IFF001W)
This is a optional White Battery & Receiver Box Set from Kyosho for their MP9 TKI3 1/8 Scale Buggy Kit.
Customise the look of your MP9
Kyosho Battery & Receiver Box Set (Orange): MP9 TKI3 (KYO KP IFF001KO)
This is a optional Orange Battery & Receiver Box Set from Kyosho for their MP9 TKI3 1/8 Scale Buggy Kit.
Customise the look of your MP9
Kyosho Rear Lower Suspension Arms (2): MP9 (KYO KP IF423)
This is a packet of (2) Rear Lower Suspension Arms from Kyosho for their MP9 1/8 Scale Buggy Kit.
Packet includes:
Packet includes:
- 2 x Rear Lower Suspension Arms
- 8 x inserts to adjust the rear track width
includes inserts to adjust rear track width
Out of Stock
$23.25 Inc Tax
Kyosho Carbon Clutch Shoes (3) (KYO KP IFW052)
This is a packet of (3) Carbon Clutch Shoes from Kyosho designed to fit all thier 1/8 off road vehicles, and can be found on select DBX vehicles as well.
These shoes last a long time, and you can fine tune the way the clutch engages by trimming about 1-2mm of the end of the clutch shoes, or by using different clutch springs.
Package includes:
These shoes last a long time, and you can fine tune the way the clutch engages by trimming about 1-2mm of the end of the clutch shoes, or by using different clutch springs.
Package includes:
- 3 x clutch shoes
- 1 x washer
Long lasting shoes for 3 shoe clutch
Kyosho 5x10 metal shielded clutch bearings (4) (KYO KP BRG001)
This is a packet of (4) 5x10 metal shielded clutch bearings from Kyosho included in most of their nitro powered kit.
Very common Nitro clutch bearings
Kyosho Front Lower Suspension Arms (2): MP9 (KYO KP IF493)
This is a packet of (2) Front Lower Suspension Arms from Kyosho for their MP9 1/8 Scale Buggy Kit.
Nice to carry a spare set in your tool box
Out of Stock
$21.50 Inc Tax
Kyosho Differential Bevel Gear Set: MP9 & MP10 (KYO KP IF402)
This is a packet of Differential Bevel Gear Set from Kyosho for their MP9 & MP10 1/8 Scale Buggy Kits.
Packet includes:
Packet includes:
- 2 x sun gears
- 4 x planetary gears
- 4 x washers
- 2 x cross pins
Keep differential operating smooth
Kyosho 5x7mm Clutch Shims (30) (KYO KP 96643)
This is a packet of (30) 5x7mm shims from Kyosho used for shimming the clutch bell bearings, and can be used with any brand of clutch system.
Packet includes:
Packet includes:
- 10 x 5x7x0.1mm shims
- 10 x 5x7x0.2mm shims
- 10 x 5x7x0.3mm shims
Includes 0.1mm, 0.2mm & 0.3mm shims
Out of Stock
$13.95 Inc Tax
Kyosho Receiver Box Set: MP9 TKI3 (KYO KP IF479)
This is a Receiver Box Set from Kyosho for their MP9 TKI3 1/8 Scale Buggy Kit.
Replacement Receiver box
Kyosho 3.5mm (63mm) Rear Shock Shaft (2): MP7/MP777/MP9/MP10/STR (KYO KP IFW149-02)
This is a packet of (2) 3.5mm Rear Shock Shaft from Kyosho included in most of their 1/8 buggy kits.
These shock shafts are 63mm long
Xtreme Racing Carbon Fiber Center Diff Top Plate: Kyosho MP9 (XTM 10727)
This is a optional Carbon Fiber Center Differential Top Plate from Xtreme Racing and is intended for use with the Kyosho MP9.
Add a little bling to your MP9
Kyosho Suspension Bushing Set (Red): MP9 TKI3 (KYO KP IF442KR)
This is a optional Red Suspension Bushing Set from Kyosho for their MP9 TKI3 1/8 Scale Buggy Kit.
This set includes 22 bushings, allowing for a variety of tuning options.
This set includes 22 bushings, allowing for a variety of tuning options.
Customise the look of your MP9
Out of Stock
$10.95 Inc Tax
Avid Racing Concepts Spring Tube Pack (8th Off-Road) (4) (AVD AV1203-TUBE)
This is a packet of (4) 8th scale spring tubes.
Now you can get all your springs organized and kept safe so that wad of springs you have in the corner of your pit box can finally find a home.
Dimensions:
- Outside: Dia. 33.3mm X Ht. 98.6mm
- Inside: Dia. 28.4mm X Ht. 96.5mm
Keep your 1/8 springs safe and tidy
Kyosho 3x29.5mm Suspension Shafts (2): MP9 (KYO KP IF425-29.5)
This is a packet of (2) 3x29.5mm Suspension Shafts from Kyosho included in their 1/8 MP9 buggy kits.
Fits all MP9 models
Kyosho 2.6x17mm Wheel Pins (4): MP9/MP10/ST-RR (KYO KP IF110)
This is a packet of (4) 2.6x17mm Wheel Pins from Kyosho for their MP9 & MP10 1/8 Scale Buggy and ST-RR Truggy Kits.
Pin to attach the wheel hubs
Kyosho 3x35mm Suspension Shafts (2): MP9 (KYO KP IF425-35)
This is a packet of (2) 3x35mm Suspension Shafts from Kyosho included in their 1/8 MP9 buggy kits.
This package also includes two screws
- 1